© 2009 MIMAKI ENGINEERING CO.,LTD.
6.4.8
P.1
R.1.0
Maintenance Manual > Disassembly and Reassembly > Drive System > Take-up Motor
Model CJV30/TPC Issued 2008.08.04 Revised
F/W ver. 1.00 Remark
1.0
6.4.8 Take-up Motor
Work procedures
1. Remove the
take-up cover (S)
.
2. Disconnect all connectors on the take-up motor PCB assy.
3. Remove the
M motor BKT (S)-Si
from the
Roll base 2(BR)
.
4. Loosen the fixing screws that connect the motor shaft and M
gear shaft (S)-Si and then remove the
M gear BKT (S)-Si
.
5. Remove the
brushless motor SK
.
6. Reverse the disassembly procedure for reassembly.
Brushless Motor SK
M Motor BKT (S)-Si
Loosen
M Gear BKT (S)-Si
M Gear Shaft (S)-Si
Brushless Motor SK
When fixing the motor shaft and M gear shaft (S)-Si
with fixing screws, be sure to tighten the screws at
the plane port of the motor shaft D cut point.
<Good example>
<Bad example>
Fixing Screw
M Gear shaft
Motor Shaft
