© 2009 MIMAKI ENGINEERING CO.,LTD.
4.3.6
P.1
R.1.0
Maintenance Manual > Adjustment Items > Mechanical Adjustment > Centering of the Roll Holder
Model CJV30/TPC Issued 2008.08.04 Revised
F/W ver. 1.00 Remark
1.0
4.3.6 Centering of the Roll Holder
Outline
Carry out centering so that the axes of roller holder (axis of both feeding side and take-up side) are aligned, by
positioning them face-to-face.
Adjustment procedure
1. Carry out centering so that the axes of roller holder are aligned by
positioning the feeding side and the take-up side face-to-face.
2. In case their axes are not aligned, make adjustment after loosening
the screws of the bushing.
3. After the both axes have been aligned, tighten up screws and check
for any misalignment of axis at the right, left and central part of
the main body.
Bad example: The axes of the right or left side of the
roller holder are out of alignment.
Good example: The axes of the roller holder
are in alignment.
Loosen
Loosen
