MIMAKI CJV150-107, Service Documents, Page: 33 / 56

© 2014 MIMAKI ENGINEERING CO.,LTD. 3.1.3 P.1
1
2
3
4
R.1.0
Service Documents > Basic Specification > Main Unit Specification > Specifications for Cutting Section
Model CJV150/300 Issued
2014.09.15
Revised F/W ver Remark
1.0
Rev.
3.1.3 Specifications for Cutting Section
 Specifications
No. Item
Specification
Remarks
CJV150/300
1 Cutting head • Up and down by the cutter solenoid
• Provided with mark sensor Cutter head is also equipped with LED pointer
and severing cutter blade
2 Cutting speed and
acceleration
Speed: 30 cm/s max.
Acceleration: 1 G max.
1 - 10 cm/s : in steps of 1 cm/s
10 - 30 cm/s : in steps of 5 cm/s
• The maximum speed may be limited depend-
ing on the media size.
• The maximum speed and the maximum accel-
eration are not available at the same time.
3 Cutting pressure 10 - 350 g 10 - 20 g : in steps of 2 g
20 - 100 g : in steps of 5 g
100 - 350 g : in steps of 10 g
4 Pens that can be used • Eccentric cutter
• Water-based ball-point pen
• Oil-based ball-point pen
• Commercially available ball-point pen for handwriting
For writing with a pen:
• Install the pen line sheet.
• The pressure must not exceed 150 g.
With a commercially available ball-point pen
• Use a pen whose diameter is

8 to

9 mm and
which is free from bumps or taper in the area
to be clamped.
• The image quality is not guaranteed because the
pen tip position differs depending on the pen.
5 Cutter response count 10 times/sec
6 Type of recommended
media
• PVC sheet (Thickness: 0.25 mm
or less *)
• Fluorescent sheet
• Reflective sheet (except high
intensity reflective sheet)
* Based on our specified media
Heat transfer rubber
sheet
7 Non-cut-
ting area
Cut sheet Outside the inner edge of pinch roller (default value)
Front: 40.0 mm Tail: 98.5 mm
Cutting area in the lateral direction:
Normal: Inside the inner edge of pinch roller
EXPANDS: Inside the outer edge of pinch roller
EXPANDS = 10 mm x 2
Roll Outside the inner edge of pinch roller (default value)
Front: 40.0 mm Tail: 0.0 mm
8 Repetition accuracy ±0.2 mm (Excluding the expansion and contraction of the
film caused by temperature) Refer to “Conditions for ensuring the repetition
accuracy” below.
9 Receive buffer mem-
ory
SD-RAM 30MB 20MB when sorting is active
10 Command MGL-II c2 MGL-I c1 is not supported
11 Program step MGL-II c2: 25 µm, 10 µm
12 Others Die cutting (Perforation cutting) Use of dedicated pen line sponge is necessary for
die cutting.