MIMAKI CF3-1610, Operation Manual

Page: 139 / 166

Adjusting the Tools
6-5
6
Tr
ou
bleshoo
ting
8
Press to make further adjustments.
Press to save the adjusted values and exit.
• To make further adjustments, press to display the adjustment screen.
Adjust Eccentricity : Operations from Step 4 on P.6-6.
Adjust
θ
Angle : Operations from Step 4 on P.6-8.
• Press to exit without saving the adjusted values.
Adjusting the Offsets
The offsets can be adjusted on the screen below.
(1) Measure the displacement between the patterns drawn with the pen and cutter (roller).
(2) Make the adjustment.
Displaced horizontally from the operation panel Displaced vertically from the operation panel
< AD J > CENTER 3 / 3
CUT TER X + 3 6 . 4 0 >
CUT TER Y + 4 5 . 4 0 >
TES T PA T TERN - >
Distance from pen to cutter (roller) with
respect to the X axis.
Press or to adjust.
(0.05 mm pitch)
Distance from pen to cutter (roller) with
respect to the Y axis.
Press or to adjust.
(0.05 mm pitch)
X-axis
Y-axis
When a drawing by the cutter is displaced to the right
(dotted line 1)
Press to set the Set value = (Current indicated value) + (Y mm).
When a drawing by the cutter is displaced to the left
(dotted line 2)
Press to set the Set value = (Current indicated value) - (Y' mm).
X-axis
Y-axis
When a drawing by the cutter is displaced downward
(dotted line 1)
Press to set the Set value = (Current indicated value) - (X mm).
When a drawing by the cutter is displaced upward
(dotted line 2)
Press to set the Set value = (Current indicated value) + (X' mm).