MIMAKI AMF-250, Operation Manual

Page: 25 / 42

- 2.11 -
Pinch roller
Guide pipe
10. Keep the right and left press cover of the guide
pipe opened, and turn the guide pipe by hand
as shown until to roll it (take it up) about 50cm.
Taking up about 50cm keeps the media almost parallel.
• The following operation contents describes for
the application of the media backside printing.
11. Pull out the clamp lever of the plotter to press
the pinch roller to the media.
Then close the guide pipe press of the Auto
Media Feeder.
12. Take up the media by the switch-Changeover/
Action and stop at approximately 10mm be-
tween the tension bar and rubber tension bar.
Tension bar
Rubber tension
bar holder
*Setting for the media backside printing