4
Attaching the Flex Shaft
Attaching Head to Flex Shaft
Putting on the Backpack
Changing Remote Batteries
Pairing the Remote
FUNCTIONAL DESCRIPTION
10
2
4
1
5
3
handle
1. Backpack
2. Backpack latch
3. Carry handle
4. Coupler locking
5. Flex shaft coupler
6. Remote storage
7. Transmit LED
8. Pairing button
10. Start/Stop button
11. Remote mode
position
12. OFF position
13. ON position
14. ONE-KEY indicator
15. Cold Start LED
16. Arm button
17. Pairing button
7
8
9
6
11
12
13
17
16
14
15
changing or removing accessories.
WARNING
Always remove battery pack before
ASSEMBLY
WARNING
Recharge
for
onl
the
y with
battery
th
.
e ch
For
arg
spe
er
-
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push the battery latch lock
to the side and squeeze the battery latch lever. Pull
the battery pack away from the machine.
To
insert
the battery, slide the pack into the body of
the machine. Make sure it latches securely into place.
WARNING
Only use accessorie
recommended for this machine.
Others may be hazardous.
Flex shafts are normally lubricated from the
manufacturer from one end. Attach the greased end
to the machine. Use a flex shaft with a length
suitable for the job.
1. Remove the battery pack.
Always remove battery pack before
changing or removing accessories.
2. Open coupler locking handle.
3. Place the flex shaft into the coupler.
4. Pull the flex shaft until the coupler locking handle
engages. (Handle will automatically fall into place
with an audible click)
WARNING
1. Remove the battery pack.
Always remove battery pack before
changing or removing accessories.
2. Coat flex shaft threads with sealant to prevent
water from entering head
3. Thread head onto flex shaft.
4. Tighten by gripping metal portion of the flex shaft
and flats of the head.
WARNING
1. Ensure backpack is securely latched to base.
2. Pick up the backpack by one of the shoulder
straps, slide your arms through each shoulder
strap.
3. With the machine on your back, tighten the
shoulder and waist straps until they fit snugly and
securely. Connect chest strap.
4. Be sure the shoulder, chest, and waist straps are
tight but comfortable; if they are too loose, the
machine may slide around on your back, making it
uncomfortable to wear.
5. Be aware machine forces may shift during use
and movement, such as twisting or bending over.
Only use alkaline batteries. Do not use zinc-carbon
batteries. If the remote will not be used for a long
time, remove the batteries as a protection against
corrosion.
To change the batteries:
1. Open the battery compartment.
2. Insert the batteries according to the polarity
marked in the compartment.
3. Close the battery compartment.
1. Arm the machine.
2. On the machine, set the switch to the position.
3. Turn on the remote.
4. On the machine, press and hold the button
until LED begins flashing (indicating machine is
ready to pair).
5. Press and hold the button on the Remote;
flashing LED on machine will turn solid then off
when the remote has paired successfully.
NOTE:
Remote needs to be within close proximity
to ensure remote is receiving signal from the
machine. This procedure will time out in 30 seconds
if machine is not paired.
Summary of Contents for MX FUEL MXF CVBP
Page 7: ......
