Milwaukee M18BMT-0, Operator'S Manual

Page: 5 / 8

5
assembly
Warning
Recharge only with the
charger specified for the battery. For specific
charging instructions, read the operator’s
manual supplied with your charger and battery.
Accessory Arbor
Type
Use adapter with this side
facing accessory
adapter not needed
adapter not needed
adapter not needed
adapter not needed
* Adapter kit available as an
accesory. Always use installation
guard and accessory bolt
provided with the kit when using
these accessories.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body of
the tool. Make sure it latches securely into place.
Changing Accessories
1. Remove the battery pack.
2. Lift the quick release lever and
push it firmly forward over the
detent.
3. Place the tool upside down on
a flat surface.
4. Unscrew the accessory bolt.
5. Remove any accessories and
adapter.
6. Clean bolt, flange, adapter
and accessories of all dirt and debris.
7. Place the adapter (if necessary), accessory and
bolt onto the tool. Determine the need for an
adapter by using the chart. Hand tighten securely.
8. Press the quick release lever back into place.
Typical
Accessory
Assemblies
1
2