4
1. Slide rail
2.
Carrying handle
3.
4.
Feed handle
5.
Battery bay
6.
Magnet activation knob
7.
Speed selector
8.
Motor adjustment lever
9.
Cutting fluid valve
10.
Cutting fluid bracket
11.
Cutting fluid bottle
OPERATION
WARNING
Always remove battery
pack before changing or removing acces
-
sories. Only use accessories specifically
recommended for this tool. Others may be
hazardous.
WARNING
To reduce the risk of injury,
wear safety goggles or glasses with side
shields.
ASSEMBLY
WARNING
Recharge only with the
charger specified for the battery. For specific
charging instructions, read the operator’s
manual supplied with your charger and battery.
Inserting/Removing the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Attaching Feed Handle
1. Line up the anvil and slide the handle into place
on the desired side of the tool.
2. To remove, press the center button and pull the
handle away from the tool.
Do not use a wrench, pipe, or any other lever in
place of the feed handle.
Motor adjustment lever
The motor adjustment lever is used to raise and
lower the motor on the slide rail. Always hold the
motor securely before loosening the adjustment
lever.
Installing the Cutting Fluid Bottle
1. Ensure the valve is in the off (sideways) position.
2. Fill the bottle with HAWG WASH® cutting fluid.
3. Attach the bottle bracket to the drill.
4. Attach the hose to the fitting on the side of the
drill.
FUNCTIONAL DESCRIPTION
Typical Operation
1. Check the work surface to make sure it is clean
and free of foreign materials.
Paint, rust, scale or uneven surfaces decrease
the holding strength of the magnet. Chips, burrs,
dirt and other foreign materials on the surface
of the magnetic base will also decrease holding
power. Use a smooth, flat file to keep the magnet
clean and free of nicks.
12.
On(I) / Off(O) switch
13.
Drill motor
14.
Cutting fluid fitting
15.
Quick-change arbor
16.
Safety strap bracket
(strap not shown)
17.
Magnetic base
LED button
The drill attaches magnetically to 6.35 mm
(1/4") or thicker ferrous stock. Do not use on
stock less than 6.35 mm (1/4"). The magnetic
base WILL NOT hold on nonmagnetic grades
of stainless steel.
1
3
2
4
5
6
7
1
3
1
2
8
1
0
9
1
1
1
4
1
6
1
5
1
7
Summary of Contents for M18 FUEL M18FMDP
Page 7: ......
