Milwaukee M18 FUEL CLT, Operator'S Manual

Page: 4 / 8

4
SYMBOLOGY
Volts
V
Direct Current
RPM
Safety Alert Symbol
Read Operator's Manual
Always wear eye protection and
hearing protection.
Always wear gloves and personal
protective equipment.
Always wear protective clothing
and footwear
Minimum
50’ 15m
Keep bystanders 15m (50') away
during use.
Objects may be thrown or ricochet in
all directions.
Do not use in rain or wet locations.
Do not use blades or brush cutting
wheels.
SPECIFICATIONS
Cat. No. ................................................... M18 CLT
Volts............................................................18V DC
Battery Type .................................................M18™
Charger Type................................................M18™
RPM ........................................... 0 - 4600 / 0 - 5800
Cutting Line ............................7.6m x 2.0mm Spiral
................................................6.1m x 2.4mm Spiral
Replacement Line 2mm...................... 49162712
2.4mm................... 49162713
ASSEMBLY
WARNING
Do not operate the tool without the
guard in place. The guard must be
attached properly when trimming. Operating the
trimmer without the guard will cause serious
injury.
Installing the Guard
The guard is shipped unin-
s t a l l e d a n d m u s t b e
installed before use.
1. Line up the guard brack-
et with the holes in the
guard.
2. I n s e r t f o u r s c r e w s
through the guard and
into the bracket.
3. Tighten the screws
securely using the in-
cluded key.
WARNING
Do not operate the tool without the
front handle in place. The front
handle must be attached properly for use when
trimming. Using one hand could cause loss of
control and result in serious injury.
Installing the Front Handle
The front handle is shipped uninstalled
and must be installed before use.
1. Place the two nuts into the front
handle detents.
2. Insert one bracket into the handle.
3. Alight the front handle with the top
of the warning sticker, just above
the "Place Handle Here" marking.
4. Wrap the other bracket around the
back of the shaft.
5. Insert the two screws through the
lower bracket and into the side
handle.
6. Tighten the screws securely using
the included key.
1. Trimmer pole
2. Front handle
3. Speed control button
4. Lock-off lever
5. Handle
6. Trigger
7. Trimmer head
8. Guard
9. Line blade
10. Spool tab
11. Line
12. Spool housing
FUNCTIONAL DESCRIPTION
1
4
3
5
6
7
9
10
8
12
11
2
Regulatory Compliance mark (RCM).
This product meets applicable
regulatory requirements.