5
•
• lead from lead-based paint
•
SYMBOLOGY
crystalline silica from bricks and cement and other
masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to
Volts
Direct Current
Rated Revolutions per Minute (RPM)
operations
SPECIFICATIONS
Cat. No. ..................................... M18 FAG125XPD
Volts .............................................................18V DC
Battery Type .................................................M18™
Charger Type ................................................M18™
Rated RPM .................................................... 8,500
Spindle Thread Size ........................................ M14
Max Capacity ............125 mm (5") x 6.35 mm (1/4")
Recommended Ambient
FUNCTIONAL DESCRIPTION
Operating Temperature .................. -17°C to 51°C
1. Spindle lock
2. Handle
3. Vent clip
5. Paddle switch
6. Side handle
7. Type 27 guard
8. Accessory
1
6
5
4
7
3
2
8
ASSEMBLY
-
WARNING
Recharge only with the charger
changing or removing accessories.
WARNING
Always remove battery pack before
manual supplied with your charger and battery.
Removing/Inserting the Battery
To
remove
the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
To reduce the risk of injury when
To
insert
the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
1.
2.
grinding, always use properly in-
stalled guards. The guard type must match the
wheel type to provide maximum protection for
the operator if the wheel should break.
Removing/Installing/Adjusting
the Type 27 Guard
This tool is shipped with a guard. Always use a guard
unless otherwise indicated by these instructions.
3.
To
remove
the guard, remove the battery pack
and remove any accessories from spindle.
Press in the guard lock lever and rotate the guard
to line up the tabs on the grinder with the slots in
the guard.
Press in the lock lever and lift the guard straight
up and away from the tool.
4.
5.
To
install
the guard, remove the battery pack and
remove any accessories from the spindle.
Line up the tabs on the grinder with the slots in
the guard.
6. Press in the guard lock lever and press the guard
onto the tool.
7. To
adjust
the guard, press in the guard lock lever
4. Switch lock-off
Read operator’s manual
Do not dispose of electric tools
together with household waste
material. Electric tools and electronic
equipment that have reached the end
of their life must be collected
separately and returned to an
environmentally compatible recycling
facility.
Regulatory Compliance Mark (RCM).
This product meets applicable
regulatory requirements.
NOTE:
Use only 125 mm (5") grinding wheels
with 125 mm (5") guards.
WARNING
Always adjust the guard to
provide the operator with
maximum protection while operating.
Wear safety glasses.
ADDITIONAL BATTERY SAFETY RULES
WARNING
WARNING
To reduce the risk of fire, personal
injury, and product damage due to
a short circuit, never immerse your tool, battery
pack or charger in fluid or allow a fluid to flow inside
them. Corrosive or conductive fluids, such as
seawater , certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a
short circuit.
Do not charge non-rechargeable
batteries.
9
9. Guard lock lever
