5
Troubleshooting
LED
Cause
Solution
Green LED flashing The battery is not sufficiently charged to
complete a pressing operation.
Charge the battery.
Red LED flashing
Device not within operating temperature
range.
Bring device into operating temperature
range (-10°C to 50°C)
Red LED on
Device fault
Retry operation. If Red LED remains lit,
return the tool, charger and battery pack,
to a
MILWAUKEE®
service facility for
repairs.
Green and Red LED
flashing alternately
Service needed
Return the tool, charger and battery
pack, to a
MILWAUKEE®
service facility
for maintenance.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
After six months to one year, depending on use,
return the tool, battery pack and charger to the
store where the product was originally purchased
or one of our authorised MILWAUKEE® service
centres for:
• Lubrication
• Mechanical inspection and cleaning (gears,
spindles, bearings, housing, etc.)
• Electrical inspection (battery pack, charger, motor)
• Testing to assure proper mechanical and
electrical operation
If the tool does not start or operate at full power
with a fully charged battery pack, clean the con-
tacts on the battery pack. If the tool still does not
work properly, return the tool, charger and battery
pack, to the store where the product was originally
purchased or one of our authorised MILWAUKEE®
service centres.
Cleaning
Clean dust and debris from charger and tool vents.
Keep tool handles clean, dry and free of oil or
MAINTENANCE
WARNING
To reduce the risk of injury,
always unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disas-
semble the tool, battery pack or charger.
Contact a MILWAUKEE® service facility for
ALL repairs.
ACCESSORIES
For a complete listing of accessories refer to your
MILWAUKEE®
accessories catalogue or go online
to milwaukeetools.com.au or milwaukeetools.co.nz.
To obtain a catalogue, contact the store where the
product was originally purchased or one of our
authorised MILWAUKEE® service centres.
WARNING
Always remove battery pack
before changing or removing accessories.
Only use accessories specifically recommend-
ed for this tool. Others may be hazardous.
grease. Use only mild soap and a damp cloth to
clean the tool, battery pack and charger since certain
cleaning agents and solvents are harmful to plastics
and other insulated parts. Some of these include
gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and house-
hold detergents containing ammonia. Never use
flammable or combustible solvents around tools.
Repairs
For repairs, return the tool, jaws, rings, battery
pack and charger to the store where the product
was originally purchased or one of our authorised
MILWAUKEE® service centres.
WARNING
To reduce the risk of per
sonal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow
a liquid to flow inside them.