5
Measuring
Milwaukee LM 60
GB
D
F
I
E
P
NL
DK
NO
S
FIN
GR
TR
CZ
SK
PL
HU
SLO
HR
LV
LT
ET
RU
BG
RO
MK
CN
Reference Setting
Default reference setting is from the rear of the
instrument.
The instrument can be set for the following measure-
ments:
•
To measure from an edge (see drawing
), fold
out the stop bracket until it snaps in for the first
time. See drawing
.
•
To measure out of a corner (see drawing
),
fold out the stop bracket until it snaps in, push
the stop bracket with a little force to the right
side; the stop bracket can now be completely
unfolded. See drawing
.
CAUTION:
Make sure that when measuring from the
unfolded endpiece, the measuring reference is set to
"End piece"!
1x briefly: the next measurement is taken from
the front edge.
2x briefly: the measurement is taken from the
unfolded end piece.
After one measurement, the reference returns auto-
matically to the default setting (rear reference).
1x long: the measurements are taken with the
front as reference until a new measuring refer-
ence is set
2x long: the measurements are taken from the
unfolded end piece until a new measuring refer-
ence is set.
See drawing
.
Measuring
Single Distance Measurement
1x briefly: the laser is activated.
1x briefly: a distance measurement is taken.
The result is displayed immediately.
Continuous measurement
Distances can be measured with this function
1x long: a "beep" is sounded.A continuous
measurement is started.
1x briefly: the continuous measurement is
stopped.
The last measured value is displayed in the summary
line.
Minimum-/Maximum-Measuring
This function enables determining the minimum or
maximum distance from a specific measuring point,
e.g. the determination of room diagonals (maximum
value) or horizontal distance (minimum value).
Summary of Contents for LM 60
Page 2: ......
Page 3: ......
Page 4: ......
Page 6: ...GB D F I E P NL DK NO S FIN GR TR CZ SK PL HU SLO HR LV LT ET RU BG RO MK CN...