13
Instruction Manual
5.1 SPARE PARTS
(Figure 5)
It is recommended that a standard group of spare
parts be kept on hand at all times to prevent serious
delays in repairs. The following list of spare parts
represents those which should be kept on hand for
each liquid end (see pump drive section for spare
parts for pump drive).
Parts orders must include the following information:
1. Quantity required.*
2. Part number.*
3. Part description.*
4. Pump serial number (include in all
correspondence regarding the pump).**
5. Full model number.**
* Found in this manual.
** Found on pump nameplate.
EXAMPLE
Four No. 435 Clevis Pins for model DB2-C-175R,
serial number IP-0009 Milton Roy Pump.
NOTE:
Unless otherwise specified, plunger size and
materials of construction of spare parts will be
the same as specified on the original pump
order.
5.2 RETURNING PUMPS TO THE FACTORY
Pumps will not be accepted for repair without a
Return Material Authorization, available from the
Factory Repair Department. Pumps returned to
the Factory for repairs should be clearly labeled
to indicate the liquid being pumped. Process liquid
should be flushed from the pump liquid end and oil
should be drained from the pump housing before
the pump is shipped.
NOTE:
Federal law prohibits handling of equipment that
is not accompanied by an OSHA Safety Data
Sheet (SDS). A completed SDS must be packed
in the shipping crate with any pump returned to
the factory. These safety precautions will aid
the troubleshooting and repair procedure and
preclude serious injury to repair personnel from
hazardous residue in pump liquid end. A Safety
Data Sheet must accompany all returns.
All inquiries or parts orders should be addressed
to your local Milton Roy representative or sent to:
www.miltonroy.com.
Item
Number
Part Name
Qty
222
Plunger Assembly
1
250
Thrust Washer
1
250
Thrust Washer Ring
1
9001
Ball Check Cartridge Assembly
2
428
Gland Bearing Liner
2
425
Packing
2 Sets
Table 3. Spare Parts for Liquid Ends with
7/16” and 5/8” Diameter Plunger.
SECTION 5 - MAINTENANCE INSTRUCTIONS-LIQUID END 7/16” AND 5/8” DIAMETER PLUNGERS
Summary of Contents for MILROYAL D
Page 23: ...19 Instruction Manual Figure 2 Polar Crank Mechanism ...
Page 31: ......
