Pellerin Milnor Corporation
3
Terminate Button
— The
Terminate
button (
) ends any running formula. When a formula
is ended early, you must restart it from the beginning by pressing one of the
Formula Selection
buttons with the door closed.
Last Rinse Light
— This light comes on when the last bath step of any formula begins and re-
mains on until the formula ends. If the operator needs to add a chemical during the last bath, such
as softener, he should add it as soon as this light comes on. The
Last Rinse
light also alerts the
operator that the machine will soon be ready for unloading.
If an error occurs during a formula, this light and the
In Progress
light flash (two seconds on,
then two seconds off) for 10 minutes. After 10 minutes, both lights go off. The error can be a mal-
function of either the door lock circuit or the inverter. In either case, all machine controls are
locked out for 75 seconds to ensure that the cylinder has coasted to a stop. To open the door after
an error occurs, press the
Terminate
button (
) to clear the error condition, then hold the
Door
Unlock
button (
) and turn the door latch handle.
In Progress Light
— When power is first applied to the machine, this light flashes for 75 sec-
onds to indicate that the power-up delay timer is counting down. The light goes off when the
power-up delay expires.
This light is constantly
on
when a formula starts (the door is closed and a formula selection but-
ton is pressed). It remains on until the formula ends normally, is terminated by the operator, or an
error occurs.
If the formula ends normally by running to completion, the
In Progress
light goes off when the
last step of the formula ends. If the operator terminates a formula, this light flashes (two seconds
on, then two seconds off) for 75 seconds as the coast timer counts down. After 75 seconds, hold
the
Door Unlock
button (
) and turn the door latch handle to open the door.
Door Unlock Button
— This button activates a solenoid in the door latch which unlocks the
door latch handle, allowing the operator to open the door. To lessen the chance of injury caused
by opening the door while the basket is turning, the microprocessor controller disables this button
when a formula starts.
The
Door Unlock
button is disabled for 75 seconds after a formula ends, whether the formula
ended normally, was ended early by the operator, or ended because of an error.
Summary of Contents for E-P OneTouch
Page 2: ......
