Milnor COELV00A, Installation And Service

Page: 18 / 35

16
Pellerin Milnor Corporation
1.4.3.2 Through Holes
BNUUUN02.T04 0000222506 A.2 B.3 A.3 11/26/19 2:51 PM Released
1. Put the bolt through the assembly.
2. Apply the threadlocker only to the bolt thread area that will engage the nut.
3. Tighten the bolt to the value shown in the correct table ( Table 6: Threadlocker by the Diame-
ter of the Bolt (see below Note ), page 12 to Table 12: Torque Values for Stainless Steel Fas-
teners 5/16-inch and Smaller, page 14 ).
Figure 3. Apply Threadlocker in a Through Hole
Application
Legend
A... No threadlocker here
B... Apply the threadlocker to this area
X... Nut depth
1.4.3.3 Disassembly
BNUUUN02.C07 0000222444 A.2 B.3 A.3 11/26/19 2:59 PM Released
For high-strength threadlocker, apply heat for five minutes. Disassemble with hand tools while
the parts are hot.
For low-strength and moderate-strength threadlocker, disassemble with hand tools.
Figure 4. Use heat for disassembly of fasteners with threadlocker.
Apply Heat to a Small Area
Legend
A... How to apply heat to a small fastener
B...
How to apply heat to a large fastener
Genereal Service Information