Milnor 30022V8Z, Maintenance Manual

Page: 27 / 200

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 6: Bearings and Bushings. See Table 7 for Motors.
Apply grease to these components to prevent damage.
Mark
1
2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
x 600 hours
bearing housing The bearing assembly is oil-filled. No routine
grease maintenance is required. Grease is
added to the seal grease cavity at assembly.
Examine the grease cavity drain tube ( Figure
14 ). If a large quantity of contamination or
water flows from the tube, maintenance can
be necessary. Speak to your dealer or
Milnor.This is not routine maintenance.
Table 7: Motor Grease Schedule. Use the data in Section 3.1.4.2 to complete this table.
Interval Quantity Dates When Grease is Added
Motor Identification
(example: main drive)
Years Hours fl oz mL
.
Table 8: Mechanisms and Settings
Make sure mechanisms are serviceable and settings are correct to prevent unsatisfactory
performance.
Mark
1
2 3 4 5 6
Do this each Component More Data
x 2400 hours
controller circuitry Examine wiring and connections in electrical
boxes. Look for corrosion, loose connections.
See Section 3.1.3
x 200 hours
bath level sensor that uses air
pressure
Examine the air tube and connections. See
Figure 11
23