Miller Trailblazer 325 Diesel, Owner'S Manual

Page: 49 / 64

Complete Parts List available at www.MillerWelds.com
OM-258900 Page 45
8-4. Adjusting Engine Speed
Engine speed is controlled by an electronic system that can only be adjusted by an engine Factory Authorized Service Station. Tampering with
the electronic governor may void engine warranty.
!
Stop engine.
When a circuit breaker or fuse
opens, it usually indicates a
more serious problem exists.
Contact a Factory Authorized
Service Agent.
1 Fuse F5
F5 protects the weld excitation
winding from overload. If F1 opens,
weld output stops or is low.
2
Supplementary Protector CB5
Protects optional Excel power
windings from overload. If this
opens, Excel power is not available
at receptacle RC3.
Place switch in On position to reset.
3
Circuit Breaker CB7
CB7 protects the engine glow plug
circuit. If CB7 opens, the glow plug
will not heat. CB7 automatically re-
sets when the fault is corrected.
4
Supplementary Protector CB8
CB8 protects the engine battery cir-
cuit. If CB8 opens, the engine will
not crank. CB8 automatically re-
sets when the fault is corrected.
Replace any open fuses. Close
door and/or reinstall cover before
operating unit.
5
Supplementary Protector CB4
CB4 protects the stator winding
supplying 24 volt AC output to Re-
mote receptacle RC4. If CB4
opens, 24 volt AC output to RC4
stops.
Press button to reset.
3/8 in.
259 872
Tools Needed:
8-5. Overload Protection
1
2
4
3
5