ProHeat Rolling Inductor FAQ
Q:
How do I access the program setup screen for the Rolling Inductor?
A:
To view the system setup screen for the Rolling Inductor, simultaneously press the
Parameters
and
Program
buttons. The following settings are available:
Deg Units Displayed (°F or °C)
Tolerance (±5 to 99)
Travel Detect (On or Off)
Control Mode (Manual, Temp, Time or Remote)
Max Output (1 Kw to 35 Kw)
System Lock (Yes or No)
(For more information on the setup screen, please consult the Rolling Inductor Owner’s
Manual)
Q:
Can I get a full 35 kW of output power with the Rolling Inductor?
A:
No, the Rolling Inductor is limited to 300 amps which results in about 20 kW of output
power. If 35 kW at 100% duty cycle is desired, a two rolling inductor arrangement is
required. The external cooler heat exchanger (300993) is recommended for two Rolling
Inductor arrangements.
(See owner’s manual for additional information on this topic)
Q:
If I already own a ProHeat 35, will the Rolling Inductor work with my system?
A:
Yes, all ProHeat 35 systems are capable of running the Rolling Inductor, but if the system was
purchased before August 2014 (serial number prior to ME320092G) a software update is
required to run the Rolling Inductor and a hardware update is required to run the Travel
Detect System (301183). If an update is needed, call Miller’s service department at 920-735-
4001 for more information on how to update your systems software.
Q:
Will the Rolling Inductor work with the Intellifire 250 or other induction power sources?
A:
No. The ProHeat 35 is the only power source that works with the Rolling Inductor.
