Miller DYNASTY 350, Owner'S Manual

Page: 54 / 136

OM-216 869 Page 48
5-11. Sequencer Controls
2
3
1
5
1 Sequencer Control
Sequencing is available while using
the TIG process, but is disabled if a
remote foot or finger current control
is connected to the Remote recep-
tacle while in the RMT STD mode.
Press switch pad until desired pa-
rameter LED is illuminated.
2
Encoder Control (Set Value)
Turn control to set values for the se-
quencer parameters.
3
Ammeter (Displays Value)
See Section 5-15 for all Sequencer
parameter ranges.
4
Voltmeter
Displays word abbreviations of se-
lected parameters.
INITIAL A ( Initial Amperage) [INTL]
- Use control to select a starting am-
perage that is different from the
weld amperage.
Application:
Initial Amperage can be used to as-
sist in preheating cold material prior
to depositing filler material, or to en-
sure a soft start.
INITIAL t ( Initial Time) [INTL]
(Available with Automation op-
tion Only) - Press control again
and turn Encoder to set amount of
time needed at the beginning of the
weld.
INITIAL SLOPE t (Initial Slope
Time) [ISLP] Use control to set
amount of time that it takes to slope
from initial amperage to weld
amperage. To disable, set to 0.
5
Amperage Switch Pad
Weld Time (Available with Au-
tomation option Only) - Press
Amperage switch pad twice. Set
desired weld time.
Spot Time - Press amperage
switch twice. Set desired spot time.
FINAL SLOPE t (Final Slope Time)
[FSLP] - Use control to set amount
of time it takes to slope from weld
amperage to final amperage. To
disable, set to 0.
Application:
Final Slope should be used while
welding materials that are crack
sensitive, and/or to eliminate the
crater at the end of the weld.
FINAL A (Final Amperage) [FNL] -
Used to set amperage to which
weld amperage slopes to.
FINAL t (Final Time) [FNL] (Avail-
able with Automation option
Only) - Press control again and turn
Encoder to set Final Amperage
time.
4