OWNER’S MANUAL
OM-267 827C
2015−05
Dynasty
210 DX and 280 DX
AC Independent Expansion
ORIGINAL INSTRUCTIONS − PRINTED IN USA
©
2015 Miller Electric Mfg. Co.
Read and follow the power source Owner’s Manual and labels carefully before installing, operating, or servicing unit.
Read the safety information at the beginning of the manual and in each section.
1-1.
Software Expansion
1
2
.
A software update is required to ensure proper
operation of all purchased feature expan-
sions. For instructions to download TIG Soft-
ware updates, see PDF file F269272A on soft-
ware expansion memory card.
Card Requirements:
.
Purchased software expansion memory card
required.
1
Memory Card Port
2
Indicator LED
Enabling Software Expansion:
Insert card containing software expansion into
port.
LED indicator blinks green while machine is read-
ing from or writing to the card. After successfully
reading from or writing to the card, the LED switch-
es from blinking green to continuous green. The
machine is now ready to use software expansion.
Do not remove card while LED is blinking green.
.
Software expansion card must remain in memory
card port to enable software expansion.
Disabling Software Expansion:
Remove the software expansion card from the
memory card port.
Troubleshooting:
Problem: Indicator LED is continuous red.
Remedy: Remove and reinsert card. If problem
continues, the card is bad. Contact Factory Autho-
rized Service Center for a replacement card.
The memory card port uses an SD memory card.
The SD Logo is a trademark of the SD-3C LLC
Company.
