Miller CST 282, Owner'S Manual

Page: 21 / 42

OM-285986 Page 15
�
Complete Parts List is available at www.MillerWelds.com
5-4. Weld Output Terminals
output term1 2015−02
1
2
Turn off power before connecting
to weld output terminals.
Do not use worn, damaged, under-
sized, or repaired cables.
1 Positive (+) Weld Output Terminal
2 Negative (−) Weld Output Terminal
�
For welding output terminal connec-
tions see Section 5-5 and 5-6 for typi-
cal connection processes.
5-5. TIG Lift-Arc DCEN (Direct Current Electrode Negative) Connections
803 943-A
3
4
5
6
2
1
7
OM-222 Page 1
allen_wrench
NGO’s
tools/
flathead philips head wrench
pliers
knife
heavy-duty workclamp light-duty workclamp wirecutter frontcutter
allen_set
needlenose
steelbrush nutdriver
chippinghammer
solderiron
stripcrimp
drill torque wrench
socket wrench
hammer awl file
crimper
paintbrush
feelergauge flashlight ruler
toothbrush
greasegun
qtip (swab)
vicegrip
handream
punch
filterwrench
strapwrench
airgun
solvent pinextractor eprompuller pipewrench
torque screwdriver
crescent wrench
11/16 in., 1-1/8 in., (21mm)
1 Positive (+) Weld Output Terminal
Connect work lead to positive weld output
terminal.
2 Negative (−) Weld Output Terminal
Connect TIG torch to negative weld output
terminal.
3 Gas Cylinder
4 Cylinder Valve
Open valve slightly so gas flow blows dirt
from valve. Close valve.
5 Regulator/Flowmeter
6 Flow Adjust
Typical flow rate is 15 cubic feet per hour
(7.1 liters per minute).
Connect torch gas hose to regulator/
flowmeter.
7 7 Gas Valve
Valve controls gas preflow and postflow.
Open valve on torch just before welding.