Miller Auto-Axcess 300 DI, Owner'S Manual

Page: 44 / 60

OM-228 874 Page 40
1 User Interface Module PC7
Diagnostic LEDs are visible inside unit,
located on PC7 mounted behind the front
panel.
Refer to Section 8-9 for information on
diagnostic LEDs.
Reinstall cover after checking diagnostic
LEDs.
2 Dip Switch S1
3 Dip Switch S2
Dip switches are used to identify each
circuit board on the internal network. Dip
switch settings are different for each circuit
board. For proper operation, do not change
dip settings from those shown.
218 559-A / 804 575-A
8-8. User Interface Module PC7 Diagnostic LEDs
2
3
1
LED1
LED2
8-9. Diagnostic LEDs On User Interface Module PC7
LED Status Diagnosis
1, 2 On See Network Status Table in Section 8-10
Off See Network Status Table in Section 8-10