Miller 907684001, Owner'S Manual

Page: 21 / 92

.
A complete Parts List is available at www.MillerWelds.com
OM-270536 Page 13
SECTION 4 − SPECIFICATIONS
4-1. Serial Number And Rating Label Location
The serial number and rating information for the power source is located on the top of the machine. Use the rating labels to determine input power
requirements and/or rated output. For future reference, write serial number in space provided on back cover of this manual.
4-2. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.millerwelds.com/eula and are incorporated by reference herein.
4-3. Information About Default Weld Parameters And Settings
NOTICE − Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical welding
parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are for reference
purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriateness of all parameters
and settings should be evaluated and modified by the end user as necessary based upon application-specific requirements. The end user is solely
responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld parameters and settings, and ultimate
quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warranties including any implied warranty of fitness
for a particular purpose.
4-4. Specifications
.
This equipment will deliver rated output at an ambient air temperature up to 104 F ( 40 C).
A. Dynasty
.
Do not use information in unit specifications table to determine electrical service requirements. See Sections 5-6, 5-8 and 5-9 for information on
connecting input power.
Welding Amperage Range Max Open Circuit Voltage (Uo) Low Open-Circuit Voltage (Uo) Rated Peak Striking Voltage
(Up)
1-210* 80 8-15*** 15KV**
*Welding range for Stick process is 5-210 amperes. For TIG, the amperage range is tungsten diameter dependent (see Sections 8-4 and/or
10-3) depending on model.
** Arc starting device is designed for manual guided operations.
*** Low open-circuit voltage while in TIG Lift Arc
t , or while in Stick with low open-circuit voltage selected.
Process
Output Ratings
Current Draw (A)
At Rate Input Voltages (V)
Input Power
Current
(A)
Voltage (V)
Duty
Cycle
Phase 208V 240V 400V 480V kW kVA
STICK
210 28.4 30%
1 40 34 20 17 8.3 8.3
3 23 20 12 10 8.0 8.4
160 26.4 60%
1 29 25 15 12 6.0 6.0
3 17 15 9 7 5.8 6.1
125 25 100%
1 22 18 11 9 4.4 4.5
3 13 11 7 6 4.5 4.6
TIG
210 18.4 60%
1 28 24 14 12 5.8 5.8
3 16 14 9 7 5.8 6.0
175 17 100%
1 22 19 12 10 4.6 4.6
3 13 11 7 6 4.6 4.8
Power Draw (W)
Idle OCV 0 77.5
−
1 83 83 91 96
− −
Idle OCV 0 77.5
−
3 93 96 101 111
− −
Idle w/ Output
Off
− − −
1 23 25 32 35
− −
Standby
− − −
1 9 11 19 25
− −
3 13 14 28 39
− −