Miller 907684001, Owner'S Manual

Page: 64 / 92

.
A complete Parts List is available at www.MillerWelds.com
OM-270536 Page 56
10-3. Accessing User Setup Menu
247216-A
MENU
1 Amperage Button
2 Gas/Dig Button
3 Parameter Display
4 Setting Display
5 Amperage Adjustment Control
To access the User functions, press
and hold the Amperage (A) and the
Gas/DIG controls until USER MENU
is displayed. To scroll through the
user menu functions, press and re-
lease the Gas/DIG control.
Rotate amperage adjustment control
to adjust parameter setting.
.
Parameter automatically returns
to amperage setting 15 seconds
after amperage adjustment con-
trol is inactive.
To exit user menu, press and release
Amperage and Gas/DIG controls at
the same time, or turn power off.
1
2
3 4
USER
2T
3/32 TUNG
RMT
ON
HOTS
5
Tungsten Diameter Selection:
Each tungsten size has preset starting parameters specific to
that diameter for optimized starting. Range is 0.020 − 1/8 in. or
0.5 − 3.2 mm. To manually set starting parameters, see Section
17-3.
Output Trigger Mode Functions:
See Section 11-4 to reconfigure RMT functions.
Arc Starting Mode Selection:
[HOTS] [ON]
Provides additional amperage while striking the electrode to pre-
vent the electrode from sticking.
[HOTS] [OFF]
No additional starting amperage to assist in starting the
electrode.