OM-250 147 Page 14
4-3. Preparing Unit For Stick Welding (Si Model)
Weld output terminals are
energized when power is On,
and Ready Light is lit.
1
Positive Weld Output
Receptacle
Connect electrode cable to this re-
ceptacle.
2
Negative Weld Output
Receptacle
Connect work cable to this recep-
tacle.
3
Power Switch
Place switch in On (I) position.
4
Ready Light (LED)
Allow time for unit to complete its
start up cycle. Light comes on
approximately two seconds after
power switch is placed in On (I) po-
sition. The light indicates that the
unit is energized and ready for
welding.
5
Amperage Adjustment Control
Set amperage, see Section 4-2.
1
4
5
2
956142809_3-6_D
3
Notes
