RB-P-K10
RBand
for Doors
www.milleredge.com
800-220-3343
3/5
IMAGE 3. RBand Edge Transmitter PCB & Connections
II.
TRANSMITTER: PROGRAM MODE
1. Confirm the Receiver is powered up. Prior to mounting the Transmitter, remove the cover and insert the batteries,
noting their polarity [IMAGE 3]. The
green LED
should blink to indicate that the Transmitter has not been
associated with the Receiver yet.
2. To enter
learn
mode, press and hold the Receiver
program button
[IMAGE 2] for ~2 seconds until the
R1 LED
turns on, then release the button.
3. Press the Transmitter
program button
[IMAGE 3] for ~2 seconds. The Receiver should
beep
. Wait 10 seconds
for an additional
beep
to indicate that programming is complete.
4. Repeat 3-2 and 3-3 for up to 3 Transmitters.
III.
TRANSMITTER: INSTALL & TEST
1. Strip back approximately 2 inches of outer covering of sensing edge cable, then feed through the Transmitter
strain relief fitting
[IMAGE 3]. Connect the two sensing edge wires to the removable terminal. Dress the wires
with a small service loop and tighten the strain relief. Mount unit utilizing the mounting holes at the 4 corners of
the Transmitter box. Return lid to Transmitter, noting the
alignment pin
[IMAGE 3].
2. Test the sensing edge for functionality: press the sensing edge and the Receiver
R1 LED
will turn on.
IV.
TROUBLESHOOTING
If the Receiver does not react to the Transmitter, you can check the RF signal strength:
1. Press the
check
button
on the Receiver for ~2 seconds [IMAGE 2]; 4 beeps will be heard. You then will hear a
beep every 1-1/2 seconds during the
check
process. Wait about 30 seconds; if no other beeps occur, your
system is functioning. 3 quick beeps indicates a communication error.
2. Activate the sensing edge and observe the
check LED
; 3-5 flashes is ideal. Less than 3 flashes means there is a
weak signal.
3. To exit
check
function, press the
check
button
again, or the system will time-out after 5 minutes. There will be a
series of beeps heard upon exiting.
V.
ERASING THE RECEIVER
Erase the Receiver if you need to replace a Transmitter or you have any other programming problems:
1. Use a screwdriver to short the two pins next to the
DIP switch
marked
MR
[IMAGE 2].
2. While shorting the pins, press and hold the
program button
for several seconds; you will hear a series of 10
beeps following by a rapid chirping sound.
3. When the chirping stops, release the
program button
. Wait ~10 seconds and you will hear 2 beeps. The
Receiver is now ready to be reprogrammed.
VI.
TECH SUPPORT
For additional assistance, contact Miller Edge Tech Support: 800-220-3343
VII.
TRANSMITTER: SPECIFICATIONS & CONTROLS
