3-
Install Receiver and Test
3-1. Mount Receiver inside the operator control box so that the wires
from the receiver will reach the terminal strip on the operator.
3-2. Wiring:
a. The red (+) and black (-) wires are your power leads. They
connect to your operator panel terminals that provide the
appropriate power (12-24 VAC/VDC). Black wire is common,
Red wire is (+) or AC power.
b. The green wire is your standard antenna wire. This must be
located outside of any metal enclosure to provide for good
signal reception. There is an F-Connector antenna fitting
included on the receiver in the event a remote antenna
placement is needed.
c.
Channel 1 Connections:
The white wire will go to your
operator’s low voltage common terminal. If your operator
requires a normally open (N.O.) contact, connect the Channel 1
yellow wire to the operator’s safety edge input. If the
operator requires a normally closed (N.C.) contact,
connect the Channel 1 orange wire to the operator’s safety edge input.
d.
Channel 2 & 3 Connections:
Follow the same procedure
as Channel 1, connecting the corresponding channel wire
leads to the desired inputs.
3-3.
Preliminary Test:
Confirm that once power is applied to the Receiver, it’s green
LED is lit. Now compress your safety edge and notice
that the correct CH 1, 2 or 3 red LED lights up on the Receiver and
the green LED lights up on the Transmitter. Repeat test for each
channel on the transmitter.
NOTE:
The 9th position coding switch is inactive.
3-4. Replace the Receiver Top Lid.
4-
Safety Test
4-1. While closing the door or gate, momentarily
activate the safety edge and confirm that
the motor stops and reverses the door or
gate direction.
CH 3
CH 2
CH 1
POWER
ANTENNA
RECEIVER ENCLOSURE
(4) PRE-DRILLED
CORNER
MOUNTING HOLES
LED
INDICATORS
MOUNTING
SCREW
HOLES
2-
Install Transmitter and Test
Cont.
2-9. The four
(4) Pre-Drilled Corner Mounting Holes
are located on the far corners of the Transmitter
Enclosure. Mount the Transmitter to the gate
post, door end stile, or bottom angle using (4)
#6 - 20 x 3/4” self-drilling screws.
Mount the transmitter with the wire outlet facing
down or to the side.
2-10. Replace the cover on the Transmitter and
tighten the
Top Lid Screws
, taking care to align
the lid.
MWRT13_Inst_201301007
9 POLE, 3 POSITION
CODING SWITCH
INSIDE RECEIVER UNIT
CH3 = RED
CH2 = RED
CH1 = RED
POWER = GREEN
F-CONNECTOR
ANTENNA
FITTING
SET DIP SWITCHES 1 THROUGH 8 IDENTICALLY TO YOUR TRANSMITTER(S)
www.GateOpenerSafety.com