background image

Mounting Plate Kit

www.milkcan.com.au

[email protected]

(03) 9464 6964

56 Northgate Drive,
Thomastown VIC 3043

MCL13038

Mounting Plate Installation 

(Figure 1, 2 & 3)

If your available space is less than this, refer to 

Reducing the Overall Width.

- Ground Surface is concrete

Your carton should contain the following parts:

2 x Mounting Plates

6 x Self-drilling Screws 

 

 

- 7, 11 & 13 line Clothesline and Ground Mount Kit are 

240cm wide.  

6 x Concrete Bolts

- Wall mounting of the clothesline is not possible and  

Ground Mount posts must be used.

Contents

The Mounting Plate Kit is required when:

Choosing a Suitable Location

Check that your chosen location has suitable side 

and front clearance. Allow 50cm side clearance and 

100cm front clearance.

- 10 line Clothesline and Ground Mount Kit are 220cm 

wide. 

2. Mark concrete through the 3 x holes on base plate. 

Repeat step for the second Mounting Plate. 

Note the side with one hole is at the front.

3. Using a hammer drill and 10mm masonry drill bit, 

drill all 6 x marked hole positions to a minimum 

depth of 80mm. Clean and prepare holes for 

installation.

4. Place the Mounting Plates in position and af x with 

the concrete bolts provided. Repeat for the second 

Mounting Plate.

1. Position Mounting Plates to match the same centre 

spacing as your Clothesline and Ground Mount Kit.

 

Reducing the Overall Width

If your available space doesn’t allow the full 

width, you can reduce the width of your 

Clothesline and Ground Mount Kit as follows:

1. For the Clothesline, refer to the Clothesline 

instruction sheet. 

2. For the Ground Mount Kit, refer to the Ground 

Mount Kit instruction sheet.

6. Insert the Ground Mount posts into the 

Mounting Plates you just installed and secure 
with the self-drilling screws through the holes 
in the Mounting Plate posts.

Note if the ground is not level you will have to 
adjust the post heights accordingly i.e. one post 
will have to be longer or shorter than the other, 
depending on the slope of the ground

5. The Ground Mount posts will need to be cut 

down in height when they are installed into the 

Mounting Plates. The amount they are cut 

down depends on the users height, we 

recommend that the cross bar be at the user’s 

10cm.

Use the chart below to see how much the posts 

should be cut.

150

155

165

170

175

160

180

Users Height 

(cm)

Cut bottom of 

Ground Mount 

post by (cm)

55

50

45

60

40

30

35

2.0

Reviews: