Bottom
of window
(wider frame)
Open
Open
Close
Close
NG
Flashback
shield (for
LPG only)
LPG Air Shutter
Slider
Open
Close
LPG
NG Air Shutter
Slider & Cover
Hot Glass Warning Plate
Window Re
tting
1. To re
t the window, hook its top part to the
rebox’s
opening frame.
Make sure that the wider part of
the window frame is at the bottom.
2. While you hold it, push in and turn the two top spring-
loaded bolts a quarter turn to engage their pin.
3. Push in the bottom of the window against the
rebox
and fasten the two bottom spring-loaded bolts a
quarter turn.
4.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
Operation Check
Turn the
replace
ame up and down using the
remote control to con
rm that the full range of inputs
is achieved—see the remote control operation
instructions on pages 9–10.
Aeration Settings
Light the
re and allow the unit to warm up for 10–15
minutes to evaluate the
ame picture. Burners are
equipped with an adjustable shutter to control primary
aeration. See the
gures below. The shutters are
factory-set to an aeration gap which will give optimum
performance for the vast majority of installations.
In a few unusual installations, the
ame picture may
be improved by adjusting the aeration. The need for
adjustment should be determined only by operating the
appliance with the ceramic logs and window installed.
Increasing aeration (open)
will cause the
ames
to appear more transparent and blue showing more
ceramic log glow.
Decreasing aeration (close)
will cause the
ames to
appear more yellow or orange showing less ceramic
log glow.
Too little aeration may result in black carbon
forming and dropping into the
fi
rebox.
Air Shutters
Operation Check & Aeration Settings Adjustment
26
QUALIFIED
INSTALLER