LOW LEVEL INPUT WIRING
Low-level (RCA) input wiring is preferred for best audio performance. Always use a high-quality
RCA cable for best audio performance.
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your
amplifier at the same time!
4-Channel Amplifier
HIGH LEVEL INPUT WIRING
The high level input(s) should only be used when your head unit lacks RCA outputs.If the RCA
outputs are not present, connect the speaker outputs from the receiver to the high level input
connector of the amplifier. Be sure to observe polarity to avoid audio phase problems.
NOTE: Do not connect BOTH the high level and low level inputs from your receiver to your
amplifier at the same time!
4-Channel Amplifier
POWER AND SPEAKER WIRING
MIL-AMP200BT
4-channel Amplifier
4-Channel Mode
+
-
-
+
SPEAKER
IMPEDANCE
4 OHMS
SPEAKER
IMPEDANCE
4 OHMS
Connecting To Bluetooth,
1.
Connection the amp is going to be largely individualistic to the device. After you turn
the device on, you have a two minute window where it puts out a pairing signal. The
blue LED light will be blinking during this time period if nothing is connected. If
something is, it will be solid blue and that device will need to be disconnected.
2.
Because of the two minute timeout, the bluetooth should be wired through a switch
and not to continuous power so that you have a way of reactivating the pairing signal if
need be.
3.
While the light is blinking, depending on your device, pull up the bluetooth menu and
find the device in your device menu. You should just then be able to click on it, but if it
prompts for a code it will be
“
1234
”
.
4.
Disconnection of a paired device is required if you want to pair another device if both
devices are in a 30ft range.
