Control Box Installation Cont’d
2-9: Complete Wiring Schematic: PEC8
CAUTION: Do Not Connect Cables to Bat-
tery until unit is completely wired to con-
trol box and installed on vehicle. Reserve
for last step of installation.
2-5: Repeat for Rear Mounting Point
2-6: Attach Tie Wrap
2-7: Clip Excess Length
10
2-10: Place Cables and Replace Washer and Nut. Tighten with 14mm Wrench.
Repeat for both motor studs.
2-8: Remove Nuts and lock washer from Motor Studs (14 mm wrench)
7. Run battery power cables carefully under hood of
vehicle, avoiding interference with moving parts and
abrasion points which could potentially cause elec-
trical short.
8. Attach Black Cable to Negative Battery Terminal
(-), followed by Red Cable to Positive Battery Termi-
nal (+) (Fig. 2-13). Refer to Winch Operation Section
of this manual for proper functioning; if drum rotates
in opposite direction when “IN” button is pressed,
blue and yellow motor cables need to be switched.
Summary of Contents for 77-50140
Page 16: ...Parts Breakdown Assembly 16...
