2.
3.
4.
5.
6.
7.
Remove both screws below the power jack and slide out the wAP PCB board;
Disconnect the grey uFL connector from the MAIN antenna connector of the modem, disconnect the black cable from the other (or AUX)
connector;
Remove two plastic doors using a flat screwdriver or similar tool and feed antenna wires through the holes and connect to the LTE6 card installed;
After you have reinserted the wAP board into the case and secured it with the screw that was removed earlier;
Slide in the SIM card from your mobile operator into the SIM slot, with the chip facing up.
The SIM slot protects the SIM card from falling out with a plastic latch. You can press the latch to the left side to unlock and then insert the SIM
card or replacing it using tweezers or a similar tool.
When using external antennas, please attach connectors to the case:
Make openings and use a 6.5 mm drill bit, and drill in any of four pre-designed spots;
Guide your
see the picture below for reference on how to place rubber seals for best water
ACSMAUFL connectors and secure them in place,
protection:
