See www.routerboard.com for more information. Contact [email protected] for support questions.
16-Oct-2012
Federal Communication Commission Interference Statement
(FCC ID:
TV7SXT-2ND
)
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-‐
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accord-‐
ance with the instructions, may cause harmful interference to radio communications. However, there is no guar-‐
antee that interference will not occur in a particular installation. If this equipment does cause harmful interfer-‐
ence to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna must not be co-‐located or operation in conjunction with any other antenna or trans-‐
mitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
13 cm minimum distance has to be maintained between the antenna and the occupational user and 28 cm to
general public. Under such configuration, the FCC radiation exposure limits set forth for an popula-‐
tion/uncontrolled environment can be satisfied.
Antenna Installation. WARNING:
It is installer's responsibility to ensure that when using the authorized antennas
in the United States (or where FCC rules apply); only those antennas certified with the product are used. The use
of any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules
CFR47 part 15.204. The installer should configure the output power level of antennas, according to country
regulations and per antenna type. Professional installation is required of equipment with connectors to ensure
compliance with health and safety issues.
CE Declaration of Conformity
Hereby MikroTik declares that this product is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. The Declaration of Conformity may be obtained
by contacting
.
