See www.routerboard.com for more information. Contact [email protected] for support questions.
3-May-2013
Resetting the device
In case you wish to return the device to its original configuration, you can use the RESET button (image Reset1). Hold this
button during boot time until LED lights start flashing, then release the button to
reset RouterOS configuration.
You can use
this procedure if you have forgotten the password to access the device, or simply wish to return the unit to its default config-‐
uration state.
Buttons and Jumpers
•
RouterBOOT reset button (image Reset1) has several functions:
ü
Hold the button before powering on the device, and at power up, the button will force load the backup boot-‐
loader. Continue holding the button for the other two functions of this button:
ü
Release the button when green LED starts flashing, to reset RouterOS configuration. To not load backup boot-‐
loader, you can start holding the button after power is already applied
ü
Release the button after LED is no longer flashing (~20 seconds) to cause device to look for Netinstall servers
(required for reinstalling RouterOS over network)
•
RouterOS reset jumper hole (image Reset2):
resets RouterOS
software to defaults. Hold screwdriver pressed to this
reset hole, and boot the device. Hold screwdriver in place until RouterOS configuration is cleared (10 seconds).
Operating System Support
Currently tested operating system is MikroTik RouterOS (starting from version 5.9).
Warranty
Copyright and Trademarks
. Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part
of it may be reproduced or transmitted in any form without prior written permission from the copyright holder. Router-‐
BOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks
appearing in this manual are the property of their respective holders.
Hardware
. MikroTik warrants all RouterBOARD series equipment for the term of one year from the shipping date to be free
of defects in materials and workmanship under normal use and service, except in case of damage caused by mechanical,
electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or other acts of nature.
To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization) procedure. Fol-‐
low the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA process.
1.
If you have purchased your product from a MikroTik Reseller, please contact the Reseller company regarding all war-‐
ranty and repair issues, the following instructions apply ONLY if you purchased your equipment directly from
MikroTik in Latvia.
2.
We do not offer repairs for products that are not covered by warranty. Exceptions can be made for RB1000, RB1100
and RB1200.
3.
Out-‐of-‐warranty devices and devices not covered by warranty sent to Mikrotik will be returned to the sender at
sender's cost.
RMA Instructions are located on our webpage here:
http://rma.mikrotik.com
Manual
. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not limited to,
the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made every effort to en-‐
sure the accuracy of the contents of this manual, however, it is possible that it may contain technical inaccuracies, typo-‐
graphical or other errors. No liability is assumed for any inaccuracy found in this publication, nor for direct or indirect, inci-‐
dental, consequential or other damages that may result from such an inaccuracy, including, but not limited to, loss of data or
profits. Please report any inaccuracies found to [email protected]
https://arttel.ru/shop/besprovodnye-sistemy/mikrotik-rb2011uias-2hnd
