www.routerboard.com
1
21/08/13
RouterBOARD 750UP
Quick Setup Guide and Warranty Information
The RB750UP is a router with five Ethernet ports. It has one USB 2.0 port, and supports PoE power output to
ports 2-‐5 (500mA maximum per port).
First use
•
Connect your WAN cable to port 1,
and LAN computers to ports 2-‐5
•
Set LAN computer IP configuration to automatic (DHCP)
•
RB750UP Default IP address from LAN is 192.168.88.1
Powering
The board accepts powering from the power jack or from the
first Ethernet port (Passive PoE):
•
direct-‐input power jack (5.5mm outside and 2mm inside, female, pin positive plug) accepts 8-‐28V DC
•
first Ethernet port accepts passive Power over Ethernet accepts 8-‐28V DC
Normally the power consumption of this device is 2.4W, under maximum load -‐ 3.6W
Power output
This RouterBOARD device can supply PoE powering to external devices from its Ethernet ports. This is convenient as
you don't need any additional PoE injectors to power other devices. This feature is indicated by the letter “P” in the
device model name. The output Voltage will be the same as input Voltage, and this feature will have to be enabled
on the specific ports in RouterOS software. By default it is disabled. Maximum power output of each ethernet port in
this mode is 500mA. Once Power Output is enabled in RouterOS, the Ethernet LED light turns from Green, to Red.
Read LED means the port is currently providing PoE power.
Booting process
This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the Ethernet
cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP address of
192.168.88.1
with the username
admin
and no password.
In case IP connection is not available, Winbox can also be used to connect to the MAC address of the device. More
information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the RESET button of
the device when starting it until the LED light turns off, and RB750 will start to look for Netinstall servers.
Extension Slots and Ports
•
Five individual Ethernet ports, supporting automatic cross/straight cable correction (Auto MDI/X), so you can
use either straight or cross-‐over cables for connecting to other network devices. The Ethernet port accepts
8-‐28 V DC powering from a passive PoE injector, 12V or more is recommended to compensate for loss in
cables.
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
