Page 24
9. Direct Configuration
You can perform some basic configuration directly on the SpeakUp without using the software. Different combinations of button presses will
allow you to record, re-record or erase commands. You’ll get feedback from the on-board LEDs. However you won’t be able to assign specific
actions with this method.
Two indicator LEDs provide the following signals:
Amber LED
- the board is ready for recording
or listening.
Red LED
- the board is perfoming an operation.
When the voice command is recognized,
both LEDs are lit for a half a second.
On-board LEDs
Use push-buttons to operate the board:
Push-button 1
- To record your voice command,
press and hold the button while speaking. You must
stay within the time limit for each command (default
settings: 1 second). You can also record multiple
commands at once by pronouncing them one by one
while keeping the button pressed. Just make sure to
wait for the red LED to flash between pronouncing
subsequent commands. Proceed in this way for as
many commands as you need. Each command will be
assigned a unique index.
Push-button 2
- If you press it for more than 2
seconds, all recorded voice commands will be erased.
If both push-buttons
are pressed for more
than 2 seconds, the SpeakUp click board will reset.
On-board push-buttons
1
2
1
2
1
2
Acceptance Threshold:
15
Recording Timeout:
5s
Word Length:
1s
Noise Level:
Auto
Notify Master:
USB
Standalone mode default settings:
