D
AT
A BUS
mikroBUS
™
pinout explained
AN
- Analog pin
RST
- Reset pin
CS
- SPI Chip Select line
SCK
- SPI Clock line
MISO
- SPI Slave Output line
MOSI
- SPI Slave Input line
+3.3V
- VCC-3.3V power line
GND
- Reference Ground
PWM
- PWM output line
INT
- Hardware Interrupt line
RX
- UART Receive line
TX
- UART Transmit line
SCL
- I2C Clock line
SDA
- I2C Data line
+5V
- VCC-5V power line
GND
- Reference Ground
Figure 7-1: Connection schematics of on-board mikroBUS
™
host sockets
connectivity
Easy
PIC PRO
v7
mikroBUS
™
sockets
page 20
Easier connectivity and simple configuration are imperative in modern electronic
devices. Success of the USB standard comes from it’s simplicity of usage and high
and reliable data transfer rates. As we in MikroElektronika see it, Plug-and-Play
devices with minimum settings are the future in embedded world too. This is why
our engineers have come up with a simple, but brilliant pinout with lines that most
of today’s accessory boards require, which almost completely eliminates the need
of additional hardware settings. We called this new standard the
mikroBUS
™
.
EasyPIC PRO
™
v7 is a development board which supports mikroBUS
™
with three
on-board sockets. As you can see, there are no additional DIP switches, or jumper
selections. Everything is already routed to the most appropriate pins of the
microcontroller sockets.
mikroBUS
™
host connector
Each mikroBUS
™
host connector consists of two 1x8 female headers containing
pins that are most likely to be used in the target accessory board. There are three
groups of communication pins:
SPI
,
UART
and
I
2
C
communication. There are also
single pins for
PWM
,
Interrupt
,
Analog
input
,
Reset
and
Chip Select
. Pinout
contains two power groups:
+5V and GND
on one header and
+3.3V and GND
on
the other 1x8 header.
Summary of Contents for EasyPIC PRO v7
Page 37: ...page 37 EasyPIC PROv7 notes...
Page 38: ...page 38 EasyPIC PROv7 notes...
