8. Support
MikroElektronika offers
Free Tech Support
(www.mikroe.com/esupport)
until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our
Libstock
website. Just download them and you are
ready to start.
6. SMD Jumpers
There are two zero-ohm resistors (SMD
jumpers):
PWR SEL
is used to determine
whether 5V or 3.3V power supply is used, and
REFERENCE
to select either VCC or 4.096V as
the voltage reference.
CS#
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
1 2 3
J2
VCC
+5V
+3V3
R3
2K2
VCC
PWR
VCC
C1
100nF
1
2
3
VIN
VOUT
VSS
REF1
MCP1541
E1
10uF
R1
100
4.096V
NOTE:
4.096V reference can be used only when
5V power supply is provided to the board
VCC
VREF
VCC-REF
VCC-REF
VCC
1
2
3
J1
SCK
SDI
1
2
3
5
4
6
7
8
VDD
CS
SCK
SDI
VREF
LDAC
GND
VOUT
U1
MCP4921
CN2
R2
10K
R4
100K
CS#
SCK
SDI
VCC
VREF
5. DAC click Board Schematics
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specification and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.
