Page 32
10. Accelerometer
Figure 10-1:
Accelerometer
module
You can set the accelerometer address to 0 or 1 by re-soldering
the SMD jumper (zero-ohm resistor) to the appropriate position.
Jumper is placed in address 1 position by default.
On board
ADXL345
accelerometer is used
to measure acceleration in three axis: x, y and
z. The accelerometer function is defined by the
user in the program loaded into the microcontroller.
Communication between the accelerometer and the
microcontroller is performed via the
I2C
interface.
Summary of Contents for 8606015071688
Page 41: ...Page 41 Notes...
Page 42: ...Page 42 Notes...
