2. Update and Registration
Before beginning a setup, update your VBar Control and VBar
NEO. Open the VBar Control Manager, plug the
Boot Plug
into
the Sensor port, connect to your computer and power up your
VBar. The LED will flash white. The update will be performed
automatically if necessary. During the update, the LED will
light up yellow briefly, then start flashing green. Disconnect the
Boot Plug and the USB wire and power cycle your VBar. If you
want to use the VBar Control Manager again (e.g. to access
the App Store), just power cycle your VBar. It will start up in
update mode again as long as the
Boot Plug
is connected.
Click on
Applications
in the VBar Control Manager to access
the App Store, where you can register your new VBar to your
MikadoID with one click of your mouse.
Perform an update of your VBar Control, too.
3. Preparing the Helicopter
First you need to assemble the helicopter in accordance with
manufacturer’s instructions. Flybarred rotor systems are not
supported. It is very important that you assemble the helicopter
mechanically correct with exact symmetry and geometry. This
is to ensure that you do not run into problems resulting from
mechanical inconsistencies later.
