Installation and Operation of the YGE controller
in LOGO 480
This YGE 90 LV controller is a special edition for Mikado
Model Helicopters. The controller has a Power-BEC and
its software is pre-programmed for LOGO helicopters. The
current version contains the internal governor (constant
head speed) and has a pre-programmed BEC voltage of
5.7 V. This YGE 90LV controller can be used with 6S lipo
batteries in the LOGO 480 without any adjustments. In its
current state, this controller can only be used in LOGO
helicopters operated by Lipo batteries of size 6S or less.
1) Position the controller on the carbon plate in front
of the motor. In this way you can measure the correct
length of the three cables connecting the motor. Then
shorten the cables as necessary. Solder the three
4 mm gold connectors and secure the connectors
with shrinking tube against short-circuiting.
2) Now attach the controller in its final position on the carbon
plate, using velcro and cable straps. Make sure that the
printed sticker faces upwards, as it contains the heat sink.
3) Connect the master wire of the YGE controller to the RX
B socket on the Mini-VBar. The slave wire (+/-) serves as
an additional power supply. It can be placed into any free
channel,
but not RX A
. The single signal wire is used only in
connection with the VBar governor (PRO-Version necessary).
Instructions for this can be found on www.vstabi.info.
4) Before powering up the motor and controller for the first
time, you must remove the main and tail rotor blades!
5) Please read the additional information and safety warnings
included to the controller by YGE. This controller can be
re-programmed using a YGE programming card. After
re-programming it can be used in other applications.
Do
not
connect the orange wire - unless
you are using PRO-Version of the (Mini-)
VBar.
additional power supply
connect to RX B (three wires)
Manual LOGO 480 - ©Mikado Model Helicopters GmbH -2013- Page 13
11 Wiring RC Components
