Initial commissioning
10/2018
Version 4.0en
Operating Manual Tabeo Sintering Oven Metal
Page 25
Removing the sintering dish from the heating
oven
Requirements
;
The sintering oven has cooled down to 300 °C to enable the oven
door to be opened.
1.
Guide the extraction pliers under the sintering dish and lift them off
the support pins.
2.
Place the sintering dish on a suitable heat-resistant surface.
Programming the heating phases
Notice
Up to nine different heating programs can be set in the program control
-
ler.
1.
Press the
Right-hand arrow
button until the LED under the
"Prog." display lights up.
2.
Select a program (1 - 9) using the
and
buttons.
3.
Press and hold the
Programming
button until the function display
shows that it is ready for input.
Â
The LED flashes.
Notice
If a button is not pressed within 60 seconds in
Programming
mode,
the program controller will skip back to the previous display.
Programming phase temperatures and holding
times
Notice
In programming mode, individual heating curves can be specified by
setting up to four phases.
Summary of Contents for TABEO Series
Page 46: ......
