MM272 Installation Instructions
25
Connect the Battery
Step 1
Place the 12 Volt automotive/lawn tractor or
marine battery and its weatherproof case within 6
feet of where the control box is mounted.
Step 2
Attach the battery wires provided to the terminals of the battery. Take care
to attach the BLACK wire to the NEGATIVE terminal and the RED wire
to the POSITIVE terminal.
Reverse connection will cause damage to the
control board
.
NOTE:
for solar installation go to
then return to next section
on Setting the CLOSED Position Limit.
Step 3
Plug the transformer into the electrical outlet. Use of a surge protector
with the transformer is
strongly
recommended. If electrical outlet
is located outdoors, outlet and transformer should be protected by a
weatherproof cover.
Set the CLOSED Position Limit for PULL-TO-OPEN
Installation
Your transmitter must be able to operate the gate. If not see, "Personalize Your Transmitter Setting on
.
Note: The OPEN limit is when the opener is fully retracted and the gate is in the full open position. The open limit setting
can only be adjusted by moving the gate bracket. To achieve the optimum closed position, you must adjust the CLOSED
limit setting:
Step 1
Make sure the Control Box switch is ON and that the gate is in the OPEN POSITION (arms fully retracted).
Step 2
Press and HOLD the 2nd opener JOG CLOSE button on the control board and be prepared to RELEASE the button when the gate
reaches the desired closed position/limit. Use the JOG OPEN and CLOSE buttons to "fine tune" the gate position if necessary.
••
••
•••
••
••
••
••
RED to POSITIVE
BLACK to NEGATIVE
Battery Cable
from Control Box
0
2
First Gate Opener
Within
6 feet
Control Box
12 Volt automotive, lawn tractor
or marine type battery in weather
proof housing (not included).
Summary of Contents for MM272
Page 43: ...MM272 Installation Instructions 39...
Page 44: ......
