13
Intercom Base Unit Installation
Find a convenient location near an approved outlet to mount
or place the intercom . Plug the transformer into the AC outlet
and connect it to the intercom’s power jack marked DC 9V .
If you are mounting the intercom on the wall, use the
template on the last page of this manual to place screws .
The intercom can be disconnected from the transformer
and used as a battery powered unit . It can be moved to any
convenient location, i .e . bedroom, patio, or garden area .
IMPORTANT:
When the Intercom unit is ON it is in the
receive mode . When plugged into the transformer it is
constantly charging the battery . The battery will last
approximately four (4) hours when unplugged from the
transformer . You can turn the unit OFF to conserve battery
power but it will not receive a signal when OFF .
Remove the battery access cover using a small
phillips head screwdriver . Plug the rechargeable
Ni-MH battery into the receptacle inside the battery
compartment . See diagram to the right . When this is
done, replace the battery access cover .
Connecting the Battery
Connecting the Transformer
ID SET
Battery Plug
Battery
POWER
Keypad
Batt Low
Grant P
ermission
Push T
o Answer/T
alk
End Call
DV 9V
Transformer
Approved 110 Vac outlet
IMPORTANT:
Once connected, allow the intercom base
unit’s battery to charge for 12 hours before using the system
for the first time .
IMPORTANT:
Allow the
intercom base unit’s battery
to charge for 12 hours before
using the system for the first
time . See page 7 for details .
