7
4. Do you have a Mighty Mule MM371W, MM372W, MM571W,
MM572W, TS571W, MM271, MM272 or HD272 Automatic
Gate Opener?
If so, these openers DO NOT require a receiver. Read the pairing instructions below:
The MM360 and select legacy systems require the installation of the RB709U-NB Universal Receiver. See
pages 8-9 for instructions on how to do so.
Learning an FM130 to an MM371W, MM372W, MM571W, MM572W or TS571W Automatic Gate
Opener.
1.
With the power on for your control box, press and
hold the gate opener's middle, orange
S3
button
(to the left of “S3” in the diagram) located on the
control board until you hear a beep, then release.
2.
Take a battery out of the green FM130 transmitter
and put it back in. The control board should
beep.
3.
Test the FM130 by closing the gate and removing
and replacing a battery in the green FM130
transmitter. If the gate opens, the FM130 has
been properly programmed to your control board.
4.
Proceed to page 7: "
Install Sensor and
Transmitter Module
".
NOTE:
If you hear three short beeps in succession, the
programming mode has timed out and you will need to
redo Steps 1-3.
To forget the FM130, simply follow steps 1 and 2 above
to verify that it no longer activates the AGO.
Learning an FM130 to an MM271, MM272 or HD272 Automatic Gate Opener
1.
Use the On/Off switch on the control box to power the system down.
2.
Take the battery out of the green FM130 transmitter and put it back in.
3.
While the red light is blinking on the FM130 transmitter, power the system on with the On/Off switch on the
control box
4.
After the startup beep, there will be a long silence for about 10 seconds, followed by a continuous beep sound.
5.
Test the FM130 by closing the gate and removing and replacing a battery in the green FM130 transmitter. If the
gate opens, the FM130 has been properly programmed to your control board.
6.
Proceed to page 7: “
Install Sensor and Transmitter Module
”.
To forget the FM130, simply follow steps 1-5 above then test the sensor to verify that it no longer activates the AGO.
NOTE for MM271:
The gate must be in the closed position with the arm extended to delete the FM130. The gate can be
in any position to learn it.
IF THE PROCESS FAILS ON THE MM271, MM272
or
HD272:
You must use a Mighty Mule transmitter with DIP switches
(FM134, FM135, MM3BT, RB741, or RB742) to program the FM130. Simply match the DIP switch patterns between the
transmitter and FM130 then learn the transmitter to the system.
Contact Tech Support for a complimentary Mighty Mule transmitter with DIP switches to program the FM130 if you do
not have one.
S4
S3
S2
LED1
LED2
LED3
