Mienta SM27209A, Instruction Manual

Page: 4 / 12

4
Instruction Manual
Using your appliance
1. Before the first use, wipe the surface of the plates with a damp cloth and dry them
well.
2. Plug the power cord into a power outlet.
3. Close the Sandwich Maker and prepare your sandwich while the unit is heating.
4. The Red light is to indicate that your appliance is plugged and is “ON”. It will remain
lit at all times when the appliance is plugged into wall.
5. The Green light is a thermostat light. It will turn “ON” when the preheating is done
and the desired temperature is reached.
6. Fully open the Sandwich Maker, place your sandwich or toast on the bottom plate.
7. Make sure the sandwich is not too thick for the sandwich maker to close. Do not
overfill and do not force shut the top cover, you risk breaking the appliance.
CAUTION: Steam can be ejected from between the plates while the appliance
is working. Take care to ensure that your fingers do not come into contact
with the steam or the hot metal plates.
8. Lock the two halves with the clip while cooking is taking place.Note: during toasting
the cooking light (green one) will turn on and off to indicate the thermostat is working
to keep the Sandwich Maker at the correct cooking temperature.
9. Your Sandwich will be toasted in 3-2 minutes, or longer to suit your taste.
10. Open the Sandwich Maker and remove the sandwich using plastic or wooden
spatula.Note: never use metal utensils as these may damage the non-stick coating.
11. Close the lid to preserve the heat until you are ready to toast the next sandwich.
12. After use, remove the plug from the power outlet and allow to cool before cleaning.
Technical specifications
Model: SM27209A / SM27209B
Power supply: 240-220V~50/60Hz
Power: 750W
Cleaning and maintenance
1. After use and before cleaning, remove plug and wait for Sandwich Maker to cool.
2. Wipe the inside and edges of the plates with a soft cloth or kitchen roll.
3. Should any filling be difficult to remove, pour a little cooking oil onto the plates, allow
to stand for 5 minutes and when the filling has softened, wipe it off.
4. Wipe the outside with a slightly moistened cloth ensuring that no moisture, oil or
filling enters the cooling slots.
5. Do not clean the inside or outside surfaces with any abrasive scouring pad or steel
wool, as this will damage the finish.