What to do if, . . .
Cause . . .
Remedy . . .
. . . the “Pre-wash”,
“Main wash” or “Rinse
1-2" indicator lamp is
flashing?
There is an internal prob-
lem.
Restart the program. If
the indicator lamp starts
flashing again, call the
Service Dept.
. . . The ”Rinse & hold“
indicator lamp is flash-
ing?
The spin speed selector
has been set to ”Without
final spin”.
Select a spin speed set-
ting.
. . . The “Final spin” in-
dicator lamp is flash-
ing?
The final spin has not
taken place. The machine
detected an imbalance.
–
Redistribute the laun-
dry load.
–
Select a spin speed.
–
Turn the program se-
lector to “Spin”.
. . . The “ON” indicator
lamp is flashing?
The child-safety feature is
activated, and the pro-
gram has been changed.
Go back to the program
originally selected.
. . . The wash is too wet
after the final spin?
The spin speed selected
was too low.
Select a higher spin
speed next time.
The load was not evenly
distributed in the drum,
and the laundry was spun
at a reduced speed to
protect the machine.
Mix large and small items
in a load to avoid imbal-
ance.
The drain pump or lint
trap is clogged.
Clean the drain pump or
lint trap.
. . . The machine
shakes during the spin
cycle?
The four feet are not rest-
ing evenly on the floor.
Level the machine (see
Installation Section).
The shipping struts have
not been removed.
Remove the shipping
struts.
Problem solving guide
26
