Programmable functions
77
Conductivity
This programmable function should
only be altered if the water is so soft
that it is likely to cause the electronics
which sense residual moisture in the
laundry to give false readings.
Options
=
Off (factory setting)
= Low
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a con-
ductivity reading (electrical conductivity)
of less than 150 μS/cm. Contact your
local water authority for the conductivity
level of your mains water supply.
Make sure that you only activate
for the condition described above.
Otherwise, drying results can be un-
satisfactory.
Control panel standby
status
To save energy the time display and
sensors will go out after 10 minutes,
and only the
Start/Stop
sensor will
flash slowly. You can change this set-
ting.
However, there is no switch-off in the
event of a fault.
Options
= Off
The time display and sensors
will remain lit up while the dryer
is switched on.
=
On (factory setting)
The time display and sensors
will go out after 10 minutes . .
. . . if no further selection is
made after switching the dryer
on.
. . . after a programme has
started.
However, the time display and
sensors will remain lit up for 10
minutes after a Delay start time
has elapsed, after the end of a
programme, or at the end of
the Anti-crease phase.
“Switching on” the display again
– Turn the programme selector to any
position (other than
) or touch a
sensor. This will not alter a running
programme.
– Open the door while the dryer is
switched on.
