Aligning the appliance
^
Turn the 4 screw feet to adjust the
dryer to the correct height and level.
Longer screw feet are available as
an optional accessory. Unscrew and
remove the feet supplied with the
dryer before fitting the longer screw
feet.
The cover plate on the dryer must
be aligned horizontally underneath
the worktop.
,
The ventilation gaps in the plinth
must not be covered over as this
would prevent a sufficient intake of
air.
Room in which the dryer is located
Air taken in for use in the drying
process will be warm when it is
expelled from underneath the dryer.
This expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. To do
this the appropriate stacking kit (WTV)
(available to order) is required.
,
The stacking kit must be fitted by
suitably qualified fitter.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out, if the dryer is tipped up when it is
being moved. It is a good idea to run
the
Cool air
programme for
approximately 1 minute before moving
the dryer. Any remaining condensed
water will then be fed into the
condensed water container or out
through the drain hose.
Installation
42
