Aligning the machine
The machine must be perfectly level to
ensure safe and proper operation.
^
The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,
The ventilation gaps in the plinth
must not be covered over as this
would prevent a sufficient intake of
air.
Room in which the dryer is located
Air taken in for use in the drying
process will be warm when it is
expelled from the rear of the dryer. This
expelled air heats up the air in the
room. It is therefore very important to
ensure that the room is adequately
ventilated, particularly if the dryer is
located in a small room. Otherwise
running times and energy consumption
could be increased.
Washer - dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. To do
this the appropriate stacking kit* (WTV)
to match your washing machine is
required.
* Available as an optional accessory
from your Miele dealer or the Miele
Spare Parts Department.
Stacking kits must be fitted by a
suitably qualified fitter.
Before moving the machine again
(e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the machine is tipped up when it
is being moved. It is a good idea to run
the
Cool air
programme for
approximately 1 minute before moving
the machine. Any remaining
condensed water will then be fed into
the condensed water container or out
through the drain hose.
Installation
37
Summary of Contents for T 4423 C
Page 44: ...44 ...
Page 45: ...Programmable functions for changing standard settings 45 ...
